Focus ZX5 L4-2.0L DOHC VIN 3 (2002)
^
Remove the timing belt upper cover.
14. CAUTION: Do not pull the cable when removing the spark plug connectors. If necessary, remove the ignition cables from the ignition coil to
avoid kinking the cables. Turn the spark plug connectors slightly before removing to loosen the seal.
CAUTION: Pull off the spark plug connectors in line with the spark plugs.
NOTE: Loosening sequence: from the outside to the inside, working diagonally.
Remove the cylinder head cover.
1. Pull off the spark plug connectors
2. Detach the PCV hose.
3. Remove ten bolts.
15. Remove the spark plugs.
16. Turn the engine to TDC on cylinder number 1.
17. Detension the timing belt.
1. Unscrew the bolt four turns.
2. Position the tensioner so the locating tab is at approximately the 4 o'clock position.
3. Line up the hex key slot in the tensioner adjusting washer with the pointer that is located behind the pulley.
18. Remove the timing belt.
19. Slacken the camshaft timing pulleys.
^
Prevent from turning using the special tool.
Installation
