Focus ZX5 L4-2.0L DOHC VIN 3 (2002)
7. While holding the adjusting washer in position, tighten the bolt.
8. CAUTION: Do not tighten the camshaft timing pulley bolts against Special Tool 303-65; use Special Tool 303-098 to prevent movement.
NOTE: The crankshaft must remain at TDC on cylinder number 1.
Tighten the bolts of the camshaft timing pulleys.
9. Unscrew and remove Special Tool 303-574.
10. Remove Special Tool 303-465 from the camshafts.
11. NOTE: Turn the crankshaft two revolutions in the normal direction of rotation.
Check the valve timing by inserting the special tool. Correct it if necessary.
^
Screw in Special Tool 303-574 and make sure that the crankshaft is touching it.
^
Insert Special Tool 303-465 into the camshafts; if necessary loosen the timing pulleys and correct the camshaft alignment.
^
Detach the special tools.
12. Screw in and tighten the blanking plug.
13. CAUTION: Use a blunt object (a plastic cable tie) to apply the silicone grease, to avoid damaging the spark plug connectors.
CAUTION: Push on the spark plug connectors, keeping them in line with the spark plugs.
NOTE: Coat the inside of the spark plug connectors with silicone grease to a depth of 5 - 10 mm.
Install the cylinder head cover and spark plugs.
1. Tighten the bolts in two stages.
^
Stage 1: 2 Nm
^
Stage 2: 7 Nm
2. Attach the PCV hose.