Focus ZX5 L4-2.0L DOHC VIN 3 (2002)
Air Bag(s) Arming and Disarming: Service and Repair
Prove Out Procedure
Prove out the system means to turn the ignition switch from position 0 to position II and visually monitor the air bag indicator with the air bag modules
and safety belt retractor pretensioners installed. The air bag indicator will light continuously for approximately six seconds and then turn off. If an air
bag SRS fault is present, the air bag indicator will either:
^
Fail to light
^
Remain lit continuously
^
Flash
The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from position 0 to position II. This is the time
required for the air bag control module to complete the testing of the SRS. If the air bag indicator is inoperative and an SRS fault exists, a chime will
sound in a pattern of five sets of five beeps. If this occurs, the air bag indicator will need to be repaired before diagnosis can continue.
