Focus ZX5 L4-2.0L DOHC VIN 3 (2002)
Air Bag Control Module: Removal and Replacement
Restraints Control Module (RCM)
Removal
WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
WARNING: To avoid accidental deployment, the restraints control module (RCM) backup power supply must be depleted. Wait at least one minute
after disconnecting the battery ground cable(s) before commencing any repair or adjustment to the supplemental restraint system (SRS), or any
component(s) adjacent to the SRS sensors. Failure to follow these instructions may result in personal injury.
WARNING: To minimize the possibility of premature deployment, do not use radio key code savers when working on the supplemental restraint
system. Failure to follow this instruction may result in personal injury.
NOTE: The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not
indicate a supplemental restraint system (SRS) fault.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Using the diagnostic tool, download the vehicle data.
2. Depower the supplemental restraint system (SRS). See: Air Bag(s) Arming and Disarming/Service and Repair
3. Remove the floor console.
4. Disconnect the restraints control module (RCM) electrical connectors.
5. NOTE: The RCM is grounded by the retaining bolts.
- Remove the RCM.
Installation
WARNING: Make sure the restraints control module (RCM) is installed correctly as detailed. The retaining bolts are part of the RCM ground circuit.
Failure to follow this instruction may result in personal injury.
WARNING: Never probe the electrical connectors of air bag modules or any other supplemental restraint system component. Failure to follow this
instruction may result in personal injury.
