Focus ZX5 L4-2.0L DOHC VIN 3 (2002)
Seat Belt: Vehicle Damage Warnings
CAUTION:
^
Make sure the retractor locating dowel is correctly located.
^
Do not attempt to remove the safety belt retractor trim cover.
^
Make sure the safety belt retractor locating tang is correctly located.
^
The bolt securing the safety belt anchor is held captive by a paper washer. The bolt, spacer and paper washer must remain on the safety belt anchor
at all times when the safety belt is detached or removed.
^
Make sure the spacer is correctly located between the floor covering and inner sill.
^
Make sure that the rear end of the anchor rail, on 3-door vehicles, is correctly located before tightening the bolt
^
Make sure the pin on the B-pillar trim is located correctly into the height adjuster.
^
Check the operation of the safety belt retractor, the cable routing and latch interlock operation before fully assembling the rear seat backrest.
