Focus ZX5 L4-2.0L DOHC VIN 3 (2002)
Seat Belt Tensioner: Service and Repair
Safety Belt Retractor and Pretensioner
REMOVAL
All Vehicles
WARNING:
^
TO AVOID ACCIDENTAL DEPLOYMENT, THE AIR BAG CONTROL MODULE BACKUP POWER SUPPLY MUST BE
DEPLETED. WAIT AT LEAST ONE MINUTE AFTER DISCONNECTING THE BATTERY GROUND CABLE(S) BEFORE
COMMENCING ANY REPAIR OR ADJUSTMENT TO THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS), OR ANY
COMPONENT(S) ADJACENT TO THE SRS SENSORS. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN
PERSONAL INJURY.
^
ALWAYS WEAR SAFETY GLASSES WHEN WORKING ON AN AIR BAG EQUIPPED VEHICLE AND WHEN HANDLING AN
AIR BAG MODULE. FAILURE TO FOLLOW THIS INSTRUCTION MAY RESULT IN PERSONAL INJURY.
^
TO MINIMIZE THE POSSIBILITY OF PREMATURE DEPLOYMENT, DO NOT USE RADIO KEY CODE SAVERS WHEN
WORKING ON THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO FOLLOW THIS INSTRUCTION MAY RESULT IN
PERSONAL INJURY.
^
NEVER PROBE THE ELECTRICAL CONNECTORS OF AIR BAG MODULES OR ANY OTHER SUPPLEMENTAL RESTRAINT
SYSTEM COMPONENT. FAILURE TO FOLLOW THIS INSTRUCTION MAY RESULT IN PERSONAL INJURY.
1. Disconnect the battery ground cable.
4-door, 5-door and wagon
2. Detach the safety belt lower anchor from the floor panel.
3-door
3. Detach the safety belt lower anchor from the floor panel.
1. Remove the bolt from the anchor rail.
2. Slide the safety belt off the anchor rail.
All vehicles
