Focus ZX5 L4-2.0L DOHC VIN 3 (2002)
Refrigerant Pressure Sensor / Switch: Service and Repair
High Pressure Cutoff Switch
REMOVAL
1. Raise and support the vehicle.
2. Disconnect the high-pressure cutoff switch electrical connector.
3. Remove the high-pressure cutoff switch.
-
Discard the O-ring seals.
NOTE: Make sure that the high-pressure cutoff switch valve closes completely after removal of the high-pressure cutoff switch to prevent loss of
refrigerant.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE:
-
Install new high-pressure cutoff switch O-ring seals.
-
Coat the high-pressure cutoff switch O-ring seals in clean refrigerant oil prior to installation.