Focus ZX5 L4-2.0L DOHC VIN 3 (2002)
Clutch Master Cylinder: Service and Repair
Vehicles With MT285/MTX-75/Manual Transaxle
Clutch Master Cylinder
Removal
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with the eyes. Wash hands thoroughly after handling. If
brake fluid contacts the eyes, flush the eyes for 15 minutes with cold running water. Get medical attention if irritation persists. If taken
internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal
injury.
1. Disconnect the battery ground cable.
2. CAUTION: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.
CAUTION: The brake fluid reservoir cap must not become contaminated.
Using a suitable syringe, remove brake fluid from the brake fluid reservoir until the brake fluid level is at the MIN mark.
-
Install the brake fluid reservoir cap.
3. Remove the air cleaner.
4. Detach the Central Junction Box (CJB) from the mounting bracket.
1. Remove the retaining bolt.
2. Release the clip.
5. CAUTION: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.
NOTE: Cap the clutch master cylinder and slave cylinder fluid supply lines to prevent fluid loss or dirt ingress.
Using a suitable thin bladed screwdriver, disconnect the clutch master cylinder and slave cylinder fluid supply lines.
-
Remove the clips.
