Focus ZX5 L4-2.0L DOHC VIN 3 (2002)
7. Tighten the strut and spring assembly top mount nuts.
Gearshift Control Shaft Seal
Gearshift Control Shaft Seal
Removal
1. Engage the third gear.
2. Raise the vehicle.
3. Open the cover on the shift and selector cable.
4. Remove the shift and selector cable.
-
Remove the shift and selector cable end fittings from the shift and selector lever.
-
Remove the shift and selector cable from the bracket by turning the lower part of abutment clockwise and the upper part counter clockwise.
5. Remove the shift and selector cable cover.