Focus ZX5 L4-2.0L DOHC VIN 3 (2002)
6. Remove the shift lever.
1. Remove the rubber cap and the securing clip.
2. Remove the shift lever. Remove the boot from the selector lever.
7. Remove the selector lever.
8. Remove the gearshift control shaft oil seal. Clean up the shaft.
Installation
1. NOTE: The third gear must be engaged.
Remove the boot from the new oil seal.
2. CAUTION: Make sure that there is no adhesive tape lost under the sealing lip of the gearshift control shaft oil seal.
NOTE: Install a thin adhesive tape to the gear shaft to avoid damages of the oil seal from the bore or from the ring groove.
Using a wrench, install the gearshift control shaft oil seal.
-
Install the boot.
