Focus ZX5 L4-2.0L DOHC VIN 3 (2002)
3. CAUTION: Leave the tie-rod end retaining nut in place to protect the ball joint stud.
Loosen the tie-rod end retaining nut.
4. CAUTION: Protect the ball joint seal using a soft cloth to prevent damage.
Using the special tool, detach the tie-rod end from the wheel knuckle.
1. Release the tie-rod end.
2. Remove and discard the tie-rod end retaining nut.
5. CAUTION: Protect the ball joint seal using a soft cloth to prevent damage.
Detach the lower arm ball joint from the wheel knuckle.
1. Remove the nut and bolt.
2. Detach the ball joint from the wheel knuckle.
-
Remove the heat shield.
6. CAUTION: Support the halfshaft. The inner joint must not be bent more than 18 degrees. The outer joint must not be bent more than 45 degrees.
Using the special tools, detach the halfshaft from the transaxle and secure it to one side.
