Freestar V6-4.2L VIN 2 (2004)
Keyless Entry Key-Pad: Description and Operation
Keyless Entry Keypad
The keyless entry keypad, located on the exterior of the driver door, provides a method for the customer to access their vehicle without a key or
remote transmitter. The keyless entry keypad feature:
-
locks all doors and liftgate while arming the perimeter alarm (if equipped).
-
unlocks only the driver door and disarms the perimeter alarm (if equipped).
-
unlocks all doors and liftgate.
-
programs/erases customer key code.
-
enables/disables autolocking.
-
opens/closes power sliding doors (if equipped).
The keyless entry keypad feature operates independently of key position status, vehicle speed, or transmission position. When a keyless entry keypad
button is pressed, the keyless entry keypad buttons illuminate to provide better visibility. If LOCK ALL DOORS is entered, or 5 seconds have elapsed
since the last button press, the illumination is turned off.
Each vehicle equipped with a keyless entry keypad is programmed with a 5-digit factory keyless entry keypad code. This code is provided to the
customer through a wallet card in the owner literature package. In addition, this code is available through a diagnostic tool and is also printed on the
SJB label. A personal keyless entry keypad code can be programmed into the SJB. When entering codes, each digit must be entered within 5 seconds
of the prior digit.
Anti-scan Feature
If the wrong code has been entered 7 times (35 consecutive button presses), the keyless entry keypad will go into an anti-scan mode. This mode
disables the keyless entry keypad for 1 minute and the keyless entry keypad lamp will flash.
The anti-scan feature will turn off after:
-
1 minute of keyless entry keypad inactivity.
-
pressing the UNLOCK button on the remote transmitter.
-
the key is turned to the ON position.
Unlocking the Doors and Liftgate with the Keyless Entry Keypad
To unlock the driver door, enter either the factory set code or the personal code (each digit must be pressed within 5 seconds of the prior digit). The
interior lamps will illuminate.
To unlock all doors, enter either the factory set code or the personal code (driver door unlocks) and press the 3/4 control within 5 seconds.
Opening and Closing the Sliding Doors with the Keyless Entry Keypad
To open or close the sliding door, enter either the factory set code or the personal code (each digit must be pressed within 5 seconds of the prior digit)
then press the 5/6 button for the driver side door or 9/0 for the passenger side door.
Locking the Doors with the Keyless Entry Keypad
It is not necessary to enter the factory set or personal code prior to locking all doors. To lock all doors, press the 7/8 and 9/0 controls at the same time.
Central Locking/Unlocking
The central locking/unlocking function is independent of the ignition switch and transmission range selector lever position. Central unlocking of all the
doors is accomplished with:
-
driver or passenger door lock control switches (unless the unlock inhibit feature is enabled).
-
two unlock commands from the remote transmitter within 3 seconds.
-
keyless entry keypad.
Central locking of all doors is accomplished with:
-
door lock control switches
-
lock command from the remote transmitter
-
keyless entry keypad (if equipped)
When the vehicle is in an armed or full-alarm security state, any unlock command from the door lock control switches will be ignored if the unlock
inhibit feature is enabled. The door lock control switches will be enabled if a valid unlock command has been received from the remote transmitter,
keyless entry keypad, or the key is cycled to ON.
Smart Junction Box (SJB) Additional Features
The SJB can also be programmed to enable/disable the following features:
-
perimeter lighting feature
-
unlock inhibit feature
Perimeter Lighting Programming
