Freestar V6-4.2L VIN 2 (2004)
6
Tighten the bolts.
7
Install the bolt plug cover.
10. If the sliding door to quarter panel does not meet specifications or if the door requires horizontal or vertical adjustment, adjust the sliding door
center roller hinge as follows:
1
Remove the center roller hinge nut.
2
Lift the rear of the door to separate the center roller hinge bracket from the center roller hinge mount bracket.
3
CAUTION: Do not swing the door open more than twenty-five degrees or damage to the other hinges may occur.
Swing the door open and support if necessary.
4
Mark the edges of the center roller hinge mount bracket.
5
Slightly loosen the bolts.
6
Re-attach the center roller hinge bracket.
7
Tap the center roller hinge into the correct position.
8
Separate the center roller hinge bracket from the center roller hinge mount bracket and tighten the bolts.
9
Re-attach the center roller hinge bracket to the center roller hinge mount bracket.
10
Install the nut.
11
Close the door and check the alignment.
11. NOTE:
-
The B-pillar and C-pillar wire strikers should be centered after steps nine and ten. For further adjustments, refer to steps three and four.
-
Make sure the screws are loosened. Adjust the upper and lower wedges.
1
Close the sliding door.
2
Open the sliding door.
