ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Trim Panel > < Headliner|Service Precautions|Page 8849
Page 3
background image

Part 2

3. Remove the parts in the order indicated in the illustration and table.

To remove individual parts, only carry out the listed steps.

Item 1: Overhead Console Removal Note

1. Unclip the console and disconnect the electrical connectors.

Item 2: Headliner Electrical Connector(s) Removal Note

1. If the headliner is not equipped with an overhead console the electrical connector will located behind the LH windshield side garnish moulding.

Disconnect the electrical connector(s).

Item 6: Sun Visor Removal Note

1. Disconnect the electrical connectors.

Item 9: Safety Belt Trim Panel Removal Note

1. Position the safety belt buckle through the panel.

Item 14: Headliner Removal Note

1. Folding the headliner will require the installation of a new headliner.

Item 15: Washer Solvent Hose Removal Note

1. WARNING:  Windshield washer solvent contains methanol which is poisonous. Observe all cautions and warnings indicated on the label

of the washer solvent container. Failure to follow these instructions may result in personal injury.

NOTE:  To prevent spilling washer solvent, drain the hose before removal.

Disconnect the washer solvent hose from the front and rear of the headliner.

INSTALLATION

1. To install, reverse the removal procedure.

Trim Panel > < Headliner|Service Precautions|Page 8849