Freestar V6-4.2L VIN 2 (2004)
Lateral Accelerometer: Service and Repair
Accelerometer
Removal and Installation
NOTE: When installing a new accelerometer, the ABS module must be configured (using vehicle as-built data) and calibrated. Follow the diagnostic
tool directions for the configuration and calibration procedures.
1. Remove the driver side front seat.
2. Remove the lower B-pillar trim panel.
3. Remove the parts in the order indicated in the following illustration and table.
4. To install, reverse the removal procedure.
Item 1: Electrical Connector Removal Note
1. Fold back the carpeting flap to gain access to the accelerometer.
