Freestar V6-4.2L VIN 2 (2004)
The power steering lines can be accessed from behind the rear of the subframe crossmember. See Figure 3.
A)
First, firmly PUSH the line into the fitting. If the line was not fully engaged, it may make a "click" noise when you PUSH on it.
B)
PULL the line away from the fitting to ensure full engagement.
C)
If the line comes out of the fitting, reinsert it, then repeat steps A through C. Check the power steering fluid level, fill if necessary and check
for leaks.
D)
Repeat steps A through C on the other line.
4.
Install the 8 mm bolt. Tighten the bolt to 6 Nm (53 lb-in).
5.
Lower the vehicle.