Freestar V6-4.2L VIN 2 (2004)
With the restraint system diagnostic tools still installed at the remaining deployable devices, prove out the supplemental restraint system (SRS).
See: Air Bag(s) Arming and Disarming/Service and Repair/Prove Out Procedure
7. Disconnect the battery ground cable and wait at least one minute.
8. WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the
supplemental restraint system (SRS) deactivation/reactivation procedure. Refer to Air Bag(s) Arming and Disarming.
Reactivate the supplemental restraint system (SRS). Refer to Air Bag(s) Arming and Disarming.
9. Connect the battery ground cable.
10. WARNING: The restraint system diagnostic tool is for restraint system service only. Remove from the vehicle prior to road use. Failure
to remove could result in injury and possible violation of vehicle safety standards.
With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS). See: Air Bag(s) Arming and
Disarming/Service and Repair/Prove Out Procedure
11. Check the active restraint system for correct operation.
Item 1: Seat Cushion Pan Installation Note
1. Bend the retaining ear back on the pressure sensor component bracket.
Item 2: Bladder, Occupant Classification Sensor (OCS) Installation Note
1. CAUTION:
-
Inspect the occupant classification sensor bladder, seat cushion pan and support assembly for any foreign objects, before installing the
occupant classification sensor to the seat cushion pan. If any foreign objects are found, remove them. Failure to do so may result in
personal injury, in the event of an air bag deployment.
