Freestar V6-4.2L VIN 2 (2004)
2. CAUTION:
-
Use care when separating the seat cushion trim cover from the hook and loop strip. The hook and loop strip can be torn from the seat
cushion foam.
-
It is necessary to rezero the OCS system when a front passenger seat cushion is disassembled, a new trim cover installed, a seat side
shield removed, or an OCS service kit is installed. A scan tool is used to trigger the active command to carry out rezeroing of the OCS
system.
If installing an OCS service kit, remove the hog rings and separate the trim cover from the foam pad.
-
After removing the hog rings, reach a hand between the trim cover and foam pad and carefully separate the hook and loop strips.
Item 17: Pressure Sensor Removal Note
1. Using a suitable tool, pry the bracket tab, releasing the pressure sensor. Separate the pressure sensor from the seat cushion pan and disconnect the
electrical connector.
Item 18: Electrical Connector Removal Note
1. Disconnect the occupant classification sensor and remove any retainers from its wiring harness.
Item 21: Occupant Classification Sensor (OCS) Removal Note
