Freestar V6-4.2L VIN 2 (2004)
7. Through the glove compartment opening, disconnect the passenger air bag module electrical connector.
8. Attach the restraint system diagnostic tool to the vehicle harness side of the passenger air bag module electrical connector.
Vehicles without safety canopies and seat side air bags
9. CAUTION: Do not deactivate the safety canopy module circuit by removing the safety canopy bridge resistor from the safety canopy
electrical connector.
If the safety canopy bridge resistor is removed, an open circuit fault will be generated by the restraints control module (RCM).
If a restraint system diagnostic tool is installed at the safety canopy electrical connector, a low resistance fault will be generated by the RCM.
10. CAUTION: Do not deactivate the side air bag module circuit by removing the side air bag bridge resistor from the side air bag floor
electrical connector.
If the side air bag bridge resistor is removed, an open circuit fault will be generated by the restraints control module (RCM).
If a restraint system diagnostic tool is installed at the side air bag floor electrical connector, a low resistance fault will be generated by the RCM.
Vehicles with safety canopies and seat side air bags
NOTE: If the headliner near each B-pillar and the outboard side of the front seat backrest trim cover has the word "AIRBAG" embossed on it, the
vehicle is equipped with safety canopy modules and seat side air bag modules.
11. Remove the safety belt guide cover.
