Freestar V6-4.2L VIN 2 (2004)
1. Release the recliner handle cover tab and remove the cover.
Item 9: Side Air Bag Module Connector Removal Note
1. If equipped, separate the side air bag module electrical connector and wire harness from the seat riser and cushion pan.
Item 10: Climate Control Seat Duct Removal Note
1. If equipped, separate the climate control duct and disconnect the backrest thermal electric device electrical connector.
2. If equipped, disconnect the two seat backrest heated seat element electrical connectors.
Item 13: Connectors Removal Note
1. If equipped, disconnect and separate the electrical connectors and wire harnesses necessary to remove the seat cushion assembly.
Item 15: Seat Cushion Assembly Removal Note
1. Remove the seat cushion assembly.
-
Disconnect and release any remaining electrical connectors and pin-type retainers necessary to separate the seat cushion pan from the seat track
and riser.
Item 16: Seat Cushion Trim Cover Removal Note
1. CAUTION: It is necessary to rezero the OCS system when a front passenger seat cushion is disassembled, a new trim cover installed, a
seat side shield removed, or an OCS service kit is installed. A scan tool is used to trigger the active command to carry out rezeroing of the
OCS system.
Release the seat cushion trim cover J-clips from the seat cushion pan.
-
If equipped, disconnect the seat cushion heated seat element electrical connector.
