Freestar V6-4.2L VIN 2 (2004)
Arming and Disarming/Service and Repair/Prove Out Procedure
11. Check the active restraint system for correct operation.
12. NOTE: When installing a new occupant classification sensor, a prepaid return postcard is provided with the new occupant classification sensor.
The serial number for the new part and the vehicle identification number (VIN) must be recorded and sent to Ford Motor Company.
Fill out the necessary information on the occupant classification sensor traceability card and return it along with the complete inoperative occupant
classification sensor to Ford Motor Company.
-
When returning the inoperative occupant classification sensor, include the following: seat cushion foam pad, bladder, electronic control unit,
pressure sensor (transducer), hose, electrical connectors and wire harness (service part occupant classification sensor only).
Item 1: Occupant Classification Sensor (OCS) (For OCS Service Kit) Installation Note
1. Bend the tab back on the pressure sensor component bracket.
2. CAUTION: Inspect the seat cushion pad and seat cushion trim cover for any foreign objects, before installing the seat cushion trim cover
to the seat cushion pad. If any foreign objects are found, remove them. Failure to do so may result in personal injury, in the event of an
air bag deployment.
Using hog rings, attach the seat cushion trim cover to the seat cushion foam pad.
-
If equipped with heated seats, make sure the wire harness is accessible after trim cover attachment.
