Freestar V6-4.2L VIN 2 (2004)
3. CAUTION:
-
Inspect the occupant classification sensor assembly, seat cushion pan and support assembly for any foreign objects before installing
the occupant classification sensor assembly to the seat cushion pan. If any foreign objects are found, remove them. Failure to do so
may result in personal injury, in the event of an air bag deployment.
-
Failure to route the seat occupant classification sensor components through the correct seat cushion support opening can cause safety
system failure.
Feed the OCS service kit components (hose, pressure sensor, electronic control unit wire harness, and connectors) through the seat cushion pan
opening.
4. CAUTION: Inspect the occupant classification sensor assembly, seat cushion pan and support assembly for any foreign objects before
installing the occupant classification sensor assembly to the seat cushion pan. If any foreign objects are found, remove them. Failure to do
so may result in personal injury, in the event of an air bag deployment.
Position the seat cushion foam pad with OCS bladder to the seat cushion pan and set in place.
5. CAUTION: It is necessary to rezero the OCS system when a front passenger seat cushion is disassembled, a new trim cover installed, a
seat side shield removed, or an OCS service kit is installed. A scan tool is used to trigger the active command to carry out rezeroing of the
OCS system.
Attach the seat cushion trim cover J-clips to the seat cushion pan.
-
If equipped with heated seats, connect the cushion element electrical connector.
