Freestar V6-4.2L VIN 2 (2004)
On some of the affected vehicles, the power steering lines may not be fully engaged into the quick connect fittings, at the rack and pinion gear assembly.
See Figure 1. This procedure involves verifying that both lines are fully engaged at the rack and pinion steering gear assembly.
SERVICE PROCEDURE
1.
Raise the vehicle on a hoist.
2.
NOTE: This bolt must be removed to ensure proper engagement of the power steering return line (low-pressure line) into the quick connect fitting
during Step 3.
Remove the 8 mm bolt securing the power steering return line (low-pressure line) to the subframe crossmember. See Figure 2.
3.
Inspect and verify both power steering line connections at the quick connect fittings as follows:
NOTE:
When checking the lines, be sure to aggressively push and pull on the lines. This is necessary due to the amount of force needed to disengage
the line from the fitting.
