Freestar V6-4.2L VIN 2 (2004)
Part 2 Of 2
3. Remove the parts in the order indicated in the following illustration and table.
To remove individual parts, only carry out the listed steps:
4. To install, reverse the removal procedure.
5. Fill and leak test the system.
6. Check and, if necessary, adjust the front end alignment.
Item 1: Outer Tie-Rod Removal Note
1. Using the special tool, separate the tie-rod end from the wheel knuckle.
Item 9: Steering Gear Removal Note
1. Remove the steering gear through the left side wheel well.
Item 9: Steering Gear Installation Note
1. Install a new steering gear through the left side wheel well.
Item 6: O-Ring Installation Note
1. Using the special tool, install new Teflon@ seals onto the power steering hoses.
