Fusion L4-2.3L VIN Z (2006)
2.
Remove the six (6) rear grommets from sheet metal (Figures 2 and 3). Use a pick tool to remove the grommets. The tabs are located 90° from the
injection marks (small round circle molded into clip) (Figure 4).
3.
Remove six (6) pins from locations (noted by the squares) on door trim panel (Figure 5) and reinstall new push pins.
4.
Add 19/32" X 3" (15mm X 75mm) piece of flock tape in locations identified by the rectangles shown in Figure 5: Two (2) on the lower front door
trim panel edge and one on lower rear door trim panel edge (Use flock tape 164-R4903 from Rotunda Squeak and Rattle Repair Kit 164-R4900).
5.
Remove inside release handle using the WSM, Section 501-14.
