Fusion L4-2.3L VIN Z (2006)
Front Door Window Glass: Service and Repair
Front
FRONT DOOR WINDOW GLASS
Removal and Installation
NOTE:
-
For Zephyr only, if installing a new LH or RH front window motor, it must be initialized.
-
For Zephyr only, the LH or RH front window motor must be de-initialized, then initialized whenever the front window motor is removed from the
window regulator drum housing, a new window regulator is installed, a new window glass is installed, a new top run is installed or for any
operation in which grease or lubricants are applied to the window regulator or glass run.
1. Remove the front door trim panel.
2. Remove the wiring harness cover plate and the access hole plug.
3. NOTE: If the window regulator motor is inoperative, remove it.
Lower the window until the glass clamp bolts can be accessed through the access holes.
4. Loosen the B-pillar front door window glass clamp bolt.
-
To install, tighten to 6 Nm (53 lb-in).
5. Loosen the A-pillar front door window glass clamp bolt.
-
To install, tighten to 6 Nm (53 lb-in).