Fusion L4-2.3L VIN Z (2006)
Seat Heater Control Module: Service and Repair
Heated Seat Module
HEATED SEAT MODULE
Worldwide Diagnostic System (WDS)
Special Tool(s)
Removal and Installation
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an airbag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
If a seat equipped with a SRS component is being serviced, the SRS must be depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a SRS fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the front seat and depower the supplemental restraint system (SRS).
2. Remove the heated seat module from the cushion electrical bracket.
-
Disconnect the heated seat module electrical connector.
-
Remove the rivet and heated seat module.
3. To install, reverse the removal procedure.
4. Install the front seat and repower the SRS. Do not prove out the SRS at this time.
5. Carry out the Zero Seat Weight Test and prove out the SRS. See: Restraint Systems/Air Bag Systems/Testing and Inspection/Component Tests
and General Diagnostics/Zero Seat Weight Test
