Fusion L4-2.3L VIN Z (2006)
4. Remove the bolt and disconnect the PCM ground.
5. Disconnect the brake tube clip, the 3 nuts and remove the PCM bracket.
6. CAUTION: Make sure that the aspirator tube is routed correctly and that the clamps are positioned so they do not make contact with surrounding
components.
Disconnect the vacuum hose/check valve assembly from the brake booster.
Automatic transmission vehicles
7. NOTE: It is not necessary to remove the fluid level indicator tube from the transmission. The tube can be positioned aside with only the bolt
removed.
Remove the transmission fluid level indicator tube bolt and position the tube aside.
^
To install, tighten to 8 Nm (71 inch lbs.).
All vehicles
8. Remove the brake booster push rod pin and clip and disconnect the push rod from the brake pedal.
9. Remove the 4 nuts and the brake booster.
^
To install, tighten to 23 Nm (17 ft. lbs.).
10. CAUTION: Prior to installation, make sure that the distance between the booster mating surface to the push rod centerpoint is as shown.
