Fusion L4-2.3L VIN Z (2006)
2. Remove the 4 screws and position the RH fender splash shield aside.
3. Remove the 6 pin-type retainers (4 shown) and the RH splash shield.
4. If equipped, remove the 7 screws and the underbody cover.
5. Remove the accessory drive belt. For additional information, refer to Drive Belts, Mounts, Brackets and Accessories.
6. Remove the valve cover.
7. CAUTION: Failure to position the No. 1 piston at top dead center (TDC) can result in damage to the engine. Turn the engine in the normal
direction of rotation only.
Using the crankshaft pulley bolt, turn the crankshaft clockwise to position the No. 1 piston at TDC.
^
The hole in the crankshaft pulley should be in the 6 o'clock position.