Fusion L4-2.3L VIN Z (2006)
C2-C3
Normal Operation
The ABS module communicates with the diagnostic tool through the high speed controller area network (CAN), circuits VDB04 (WH/BU) and
VDB05 (WH).
Check the high speed CAN circuits VDB04 (WH/BU) and VDB05 (WH) between the ABS module C135 and the data link connector (DLC) C251.
The total resistance values must not be more than 5 ohms. If the resistance is more than 5 ohms there is an open in one of the high speed CAN
circuits, damage to the DLC C251, damage to the ABS module C135, or a problem in an in-line connector.
Possible Causes
-
high speed CAN data plus circuit VDB04 (WH/BU) open
-
high speed CAN data minus circuit VDB05 (WH) open
-
ABS module C135
-
ABS module
Test D: The Restraint Control Module (RCM) Does Not Respond To The Diagnostic Tool
PINPOINT TEST D: THE RESTRAINT CONTROL MODULE (RCM) DOES NOT RESPOND TO THE DIAGNOSTIC TOOL