Fusion L4-2.3L VIN Z (2006)
-
The evaporative emission system contains fuel vapor and condensed fuel vapor. Although not present in large quantities, it still presents the danger
of explosion or fire. Disconnect the battery ground cable from the battery to minimize the possibility of an electrical spark occurring, which can
cause a fire or explosion if fuel vapor or liquefied fuel are present in the area. Failure to follow these instructions can result in personal injury.
-
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable mixtures
are always present and may be ignited, resulting in possible personal injury.
-
Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related
components. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions can result in personal injury.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Disconnect the evaporative emission (EVAP) canister vent solenoid electrical connector
4. Disconnect the fuel vapor hose from the EVAP canister vent solenoid and dust separator assembly.
5. Disconnect the 2 quick connect couplings from the EVAP canister assembly.
6. Remove the 2 nuts, 2 bolts and the EVAP canister assembly.
-
To install, tighten to 6 Nm (53 lb-in).
7. To install, reverse the removal procedure.
-
Carry out the evaporative emission system leak test. See: Testing and Inspection/Evaporative Emission System Leak Test
-
Carry out the evaporative emission repair verification drive cycle. See: Testing and Inspection/Evaporative Emission Repair Verification
Drive Cycle
