Fusion L4-2.3L VIN Z (2006)
2. Remove the 2 nuts, the bolt and the generator air inlet duct.
-
To install, tighten to 6 Nm (53 lb-in).
3. Disconnect the 4 ignition coil-on-plug electrical connectors.
4. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
Remove the 4 bolts and the ignition coil-on-plugs.
-
To install, tighten to 10 Nm (89 lb-in).
5. To install, reverse the removal procedure.
-
Apply a small amount of dielectric grease to the inside of the ignition coil-on-plug boots before attaching to the spark plugs.
