Fusion L4-2.3L VIN Z (2006)
9. Move the seat to the forward most position.
-
If equipped with a power seat track, apply power and ground to the pins shown.
10. Remove the 2 rear bolts from the affected OCS rail.
11. Move the seat to the rearward most position.
-
If equipped with a power seat track, apply power and ground to the pins shown.
12. NOTE: Note what position the locator pin on the OCS rail goes through the OCS rail shield and into the rear mounting point of the seat track for
installation.
Remove the 2 front bolts and the affected OCS rail and shield.
-
Release the OCS rail shield rear tab from the OCS rail.
Installation
All occupant classification sensor (OCS) rails
NOTE: If installing a new seat track, position the seat track so the seat will be in the rearward most position before starting installation of the
occupant classification sensor (OCS) rails.
1. WARNING: The occupant classification sensor rail shield is an aid to prevent foreign material and contaminants from entering the
occupant classification sensor rail. Make sure the occupant classification sensor rail shield is present, is not damaged and is correctly
installed to the occupant classification sensor rail. Failure to follow these instructions may increase the risk of personal injury or death in
a crash.