Fusion L4-2.3L VIN Z (2006)
1. CAUTION: Only hand-tighten the bolt or damage to the front cover can occur.
Install a 6 mm (0.23 in) x 18 mm (0.7 in) standard bolt in the crankshaft pulley.
2. Install the CKP sensor and the 2 bolts.
-
Do not tighten the bolts at this time.
3. NOTE: The CKP sensor alignment tool is supplied with the new sensor and is not available separately.
Adjust the CKP sensor with the alignment jig.
-
Tighten the 2 CKP bolts to 7 Nm (62 lb-in).
4. Remove the 6 mm (0.23 in) bolt from the crankshaft pulley.
5. Install the cylinder block plug.
-
Tighten to 10 Nm (89 lb-in).
6. Install the 6 pin-type retainers (4 shown) and the RH splash shield.
7. Install the 4 screws and position the RH fender splash shield aside.
8. Connect the battery ground cable.
