Fusion L4-2.3L VIN Z (2006)
3. If equipped, remove the 7 screws and the underbody cover.
4. Remove the starter motor solenoid wire nut and position the wire aside.
-
To install, tighten to 5 Nm (44 lb-in).
5. Position the starter motor solenoid battery cable terminal cover aside.
6. Remove the starter motor solenoid battery cable nut and position the cable aside.
-
To install, tighten to 12 Nm (9 lb-ft).
7. Disconnect the wiring harness retainer from the top and bottom starter motor stud bolt and position the wiring harness aside.
8. Remove the 2 starter motor stud bolts and the starter.
-
To install, tighten to 25 Nm (18 lb-ft).
9. To install, reverse the removal procedure.
