Fusion L4-2.3L VIN Z (2006)
Rear Door Window Motor: Service and Repair
Rear Door Window Regulator and Motor
REAR DOOR WINDOW REGULATOR AND MOTOR
Removal and Installation
1. Remove the rear door trim panel.
2. Remove the access hole plugs.
3. NOTE: If the door window regulator motor is inoperative, remove it.
Lower the window until the glass clamp bolts are accessible through the access hole plugs, then loosen the glass clamp bolts.
-
To install, tighten to 6 Nm (53 lb-in).
4. Tape the window in position, then lower the window regulator downward until it reaches the stops at the bottom of the regulator tracks.
5. Remove the door speaker.
6. Remove the interior door handle screw and position the door handle aside.