ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Brake Pads > < Front Disc Brake

Fusion 2002.75 (06.2002-)

Front Disc Brake - Brake Caliper Fusion 2002.75 (06/2002-)
Removal and Installation

General Equipment
Brake hose clamp
Materials
Name
Specification
Silicone Grease
ESE-M1C171-A 

Removal

CAUTION:
CAUTION:If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.
  1. Remove the wheel and tire.
    For additional information, refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

  1. Remove the brake caliper retaining clip.

  1. CAUTION:
    CAUTION:Cap the brake hose to prevent fluid loss or dirt ingress.
    NOTE:
    NOTE:Use a wrench to prevent the brake hose from rotating.
    Disconnect the brake hose from the brake caliper.
    1. Using a brake hose clamp, clamp the brake hose.
    1. Disconnect the brake hose.

  1. Remove the brake caliper.
    1. Remove the brake caliper retaining bolt covers (if equipped).
    1. Remove the brake caliper retaining bolts.

  1. Remove the brake pads.

Installation

  1. CAUTION:
    CAUTION:Do not twist the brake hose when connecting the brake hose to the brake caliper to prevent damage to the brake hose.
    To install, reverse the removal procedure.
    • Apply grease to the brake pad contact points.
  1. Bleed the brake system. For additional information, refer to: (206-00 Brake System - General Information)
    Brake System Bleeding (General Procedures),
    Brake System Pressure Bleeding (General Procedures).

Brake Pads > < Front Disc Brake