ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Center Register Air Discharge Temperature Sensor > < Blower Motor Switch

Fusion 2002.75 (06.2002-)

Control Components - Air Inlet Blend Door Actuator Fusion 2002.75 (06/2002-)
Removal and Installation

Removal

Left-hand drive vehicles.
  1. Remove the glove compartment.
RHD vehicles
  1. Open the stowage space and remove the screws for the dashboard lower trim.

  1. Detach the dashboard lower trim from the dashboard.
All vehicles
  1. Remove the actuator - air distribution flap.
    1. Disconnect the connector for the air distribution flap actuator.
    1. Remove the screws.
    1. Remove the air distribution flap actuator from the flap shaft.

Installation

  1. NOTE:
    NOTE:After installing the air distribution flap actuator, initialise the air distribution flap actuator using the air conditioning system control panel. To do this, press the "Footwell" and "OFF" buttons simultaneously, then press the "Auto" button.
    To install, reverse the removal procedure.

Center Register Air Discharge Temperature Sensor > < Blower Motor Switch