Fusion AWD L4-2.3L (2008)
2. With a wax pencil, mark the relationship alignment of the rear subframe to the underbody at the mounting locations.
3. Remove the LH and RH rear lower arms.
4. Remove the catalytic converter, muffler and tailpipe as an assembly.
All-Wheel Drive (AWD) only
5. NOTE: Index-mark the rear axle pinion flange and the driveshaft yoke.
Remove the 4 driveshaft bolts.
-
To install, tighten to 83 Nm (61 lb-ft).
All vehicles
6. Remove the bolt from the LH and RH wheel speed sensors.
7. Remove the RH and LH wheel speed sensor nuts from the stud and position aside.
