Fusion AWD L4-2.3L (2008)
1. Position the front seats in the full forward position.
2. NOTE: Inspect the safety belt D-ring cover for damage. If the safety belt D-ring cover does not remain in place, install a new cover.
Remove the safety belt D-ring cover and remove the safety belt bolt.
-
To install, tighten to 54 Nm (40 lb-ft).
3. Position the front and rear door weatherstrips aside.
4. Remove the front door scuff plate trim panel.
5. Remove the rear door scuff plate trim panel.
6. Remove the lower B-pillar trim panel.
-
Slide the lower B-pillar trim panel down to disengage it from the upper B-pillar trim panel.
7. Remove the upper B-pillar trim panel.
-
Remove the screw cover.
-
Remove the screw.
8. To install, reverse the removal procedure.