Fusion AWD L4-2.3L (2008)
Keyless Entry Transmitter: Testing and Inspection
Remote Keyless Entry Transmitter Programming
REMOTE KEYLESS ENTRY TRANSMITTER PROGRAMMING
NOTE:
-
This procedure is for programming conventional keyfobs only. The remote keyless entry (RKE) transmitter of the integrated keyhead transmitter
(IKT) is programmed automatically during passive anti-theft system (PATS) programming. For additional information, refer to Key Programming
Using Two Programmed Keys or IKT Key Programming Using Diagnostic Equipment in Antitheft and Alarm Systems to program the IKT. See:
Testing and Inspection/Key Programming Using Two Programmed Keys See: Testing and Inspection/Integrated Keyhead Transmitter (IKT) Key
Programming Using Diagnostic Equipment
-
All remote keyless entry (RKE) transmitters must be programmed at the same time.
-
Do not apply the brake pedal during this sequencing, as doing so ends the sequence and the transmitters will not be programmed.
1. Electronically unlock the door locks using the door lock control switch.
2. Cycle the ignition switch from the OFF to the ON position 8 times in rapid succession (within 10 seconds), with the eighth turn ending in ON. If
the module successfully enters program mode, it locks and then unlocks all the doors.
3. NOTE: If no action is taken within 20 seconds after a transmitter has been programmed, the programming sequence ends (the doors lock and
unlock to confirm that programming is complete).
Within 20 seconds, press any button on the RKE transmitter to be programmed. The doors lock and then unlock to confirm that each RKE
transmitter is programmed. Repeat this step for each RKE transmitter.
4. Exiting the programming mode is accomplished if one of the following occurs:
-
The key transitions to the OFF position.
-
20 seconds have passed since entering programming mode or since the last RKE transmitter was programmed.
-
The maximum number (6) of RKE transmitters have been programmed.
5. Check the operation of the transmitter. If the door locks do not respond for the programmed RKE transmitter(s), wait several seconds and press the
button again. If the door locks still fail to respond, check the operation of the door locks using an IKT. If the door locks fail to respond with an
IKT, refer to Locks, Latches and Entry Systems. (Make sure that no more than the maximum number of RKE transmitters (6) are attempted to be
programmed.)
