Fusion AWD L4-2.3L (2008)
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Only the front passenger seat can come equipped with optional fold-flat backrest.
1. Remove the front seat.
2. Fold the seat backrest down to the fold-flat position.
3. Remove the spring clip and manual recliner handle.
4. Remove the cushion side shield in the following sequence.
1
Pull out on the side and rear of the cushion side shield, releasing the retainers.
2
Separate the wire harness pin-type retainers from the cushion side shield.
3
Remove the cushion side shield.
5. Remove the RH recliner outboard cover retainer cover.
6. Pull the head of the RH recliner outboard cover retainer up to release, then remove the retainer.
7. Remove the RH recliner outboard cover in the following sequence.
1
Pull out on the RH recliner outboard cover at the front and rear to release the cover retainers and at the bottom, pull the cover away from the
recliner.
2
Slide the RH recliner outboard cover back to separate from the recliner.
8. Route out the side air bag wire harness and remove the RH recliner outboard cover.
9. Pull the head of the LH recliner outboard cover retainer up to release, then remove the retainer.
