Fusion AWD L4-2.3L (2008)
8. Loosen the brake caliper bleeder screw.
9. Using the special tool, fully retract the brake caliper piston and tighten the bleeder screw to 8 Nm (71 lb-inch).
10. Repeat Steps 4 through 9 until clear, bubble free fluid comes out.
^
Refill the brake master cylinder reservoir as necessary.
^
Remove the rubber hose and install the bleeder screw cap.
11. Remove the 2 guide pin bolts and the shop towel.
12. Install the outer brake pad.
13. Position the brake caliper and install the 2 guide pin bolts.
^
Tighten to 26 Nm (19 lb-ft).
