Fusion AWD L4-2.3L (2008)
3. NOTE: Note the position of the side air bag module locator hook in the side air bag module bracket (on the seat back frame) for installation.
Remove the bolt and lift up and out, to detach the side air bag module from the seat back.
-
To install, tighten to 10 Nm (89 lb-in).
4. Slide and disengage the side air bag module electrical connector locking clip, and then release the tab and disconnect the side air bag module
electrical connector.
5. WARNING:
-
Inspect the seat side air bag module cavity in the seat backrest foam pad for any foreign material. If any foreign material is found,
remove it. Failure to follow these instructions may result in the seat side air bag module deploying incorrectly and increases the risk of
serious personal injury or death in a crash.
-
If the seat side air bag cover has been damaged or separated from its mounting, or if the air bag material has been exposed, install a
new seat side air bag module. Never try to repair the seat side air bag module. Failure to follow these instructions may result in the
seat side air bag deploying incorrectly, which increases the risk of serious personal injury or death in a crash.
To install, reverse the removal procedure.
6. Repower the SRS
