Fusion AWD L4-2.3L (2008)
8. Install the 2 outer tie-rod end nuts.
^
Tighten to 48 Nm (35 lb-ft).
^
Install 2 new cotter pins.
9. If equipped, install the underbody splash shield and bolts.
^
Tighten to 7 Nm (62 lb-in).
10. NOTE: RH side shown, LH side similar.
Install the LH and RH splash shield and the 6 pin-type retainers (4 shown).
11. NOTE: RH side shown, LH side similar.
Install the RH and LH fender splash shield and the 4 screws from each side.
12. Install the pressure line bracket-to- steering gear bolt.
^
Tighten to 15 Nm (11 lb-ft).
13. CAUTION: New banjo bolts and new seals must be installed any time the power steering pressure line is disconnected from the power
steering pump and/or the steering gear or a fluid leak may occur.
Install the pressure line-to-steering gear banjo bolt and seals.
^
Tighten to 55 Nm (41 lb-ft).