Fusion AWD L4-2.3L (2008)
6. Position the power distribution box (PDB) aside.
1
Remove the 2 PDB bolts and the lower nut. Pull the PDB upward to unclip the pushpin.
2
Disconnect the 2 electrical connectors.
7. Position a suitable floor jack under the transaxle.
8. Remove the remaining 2 transaxle rear support insulator-to-frame bolts, the 2 transaxle rear support insulator nuts and the transaxle rear support
insulator-to-transaxle bolt.
^
If one or both of the mount studs are removed or come out, do not reinstall the old stud(s). Install a new stud(s). Make sure the they are
properly seated in the case.
^
To install, tighten to 63 Nm (46 lb-ft).
9. Remove the clutch hydraulic tube spring clip. Push downward on the clutch tube to release it from the bracket.
