Fusion AWD L4-2.3L (2008)
3. NOTE: Index-mark both the driveshaft flanges for installation.
Remove the 4 driveshaft-to-power transfer unit (PTU) output flange bolts. Disconnect the driveshaft from the PTU and position it aside.
^
Using mechanic's wire, support the driveshaft.
4. NOTE: Rotational torque of the PTU rear output shaft flange must be measured and recorded using a Nm (lb-in) torque wrench for correct pinion
bearing preload when reassembled. This will be the torque-to-turn measurement.
Using a suitable torque wrench, measure and record the rotational torque.
5. Using the special tool, hold the output pinion flange and remove and discard the pinion nut.
6. NOTE: Index-mark the output pinion flange to the pinion shaft.
Using the special tool, remove the output pinion flange.
7. Remove and discard the output shaft seal deflector.
8. Remove and discard the output shaft seal.
9. Remove and discard the collapsible spacer.
Installation