Fusion AWD V6-3.0L (2009)
Communications Control Module: Removal and Replacement
Audio Control Module (ACM) - Fusion, Milan
Audio Control Module (ACM) - Fusion, Milan
Removal and Installation
NOTE: It is not necessary to remove the Audio Control Module (ACM) to retrieve the part number. For additional information, refer to Audio Unit Part
Number Retrieval See: Procedures/Audio Unit Part Number Retrieval.
1. NOTE: Module configuration is only required if a new ACM is being installed.
Upload the ACM configuration information to the scan tool.
2. Remove the instrument panel center finish panel.
-
Disengage the clips.
3. Remove the 4 screws and the ACM.
-
Disconnect the electrical connectors and the antenna lead-in cable.
4. To install, reverse the removal procedure.
-
Download the configuration information to the ACM.
Audio Digital Signal Processing (DSP) Module
Audio Digital Signal Processing (DSP) Module
