Fusion AWD V6-3.0L (2009)
19. Attach the glove compartment door damper cable and close the glove compartment door.
All vehicles
20. NOTICE: Do not install the driver air bag module electrical connectors by the locking buttons. Damage to the locking buttons can occur.
NOTICE: The driver air bag module electrical connector locking buttons must be in the released position when the connector is being
installed, or connector damage may occur.
NOTICE: The driver air bag module electrical connectors are unique and cannot be reversed when connected to the driver air bag
module. Match the electrical connector key to the keyway in the driver air bag module. Do not force the electrical connectors into the
driver air bag module.
With the locking buttons released, install the driver air bag module electrical connectors fully into the driver air bag module and seat the locking
buttons.
21. NOTE: Audible clicks will be heard when both wire clips are seated in the driver air bag module.
Align the driver air bag module locking pins to the steering wheel and, while pushing inward, seat the 2 driver air bag module locking pins in the
steering wheel wire clips.
-
When the 2 locking pins are seated in place, there should be an even gap between the driver air bag module trim cover and the steering wheel.
22. Turn the ignition switch from OFF to ON.
23. Install RCM fuse 25 (7.5A) to the SJB and close the cover.
24. WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any air bag module when the battery is
connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
Connect the battery ground cable.
