Fusion AWD V6-3.0L (2009)
18. Install the RH recliner outboard cover, retainer and retainer cover.
-
Route the side air bag wire harness to the RH recliner outboard cover.
19. Install a new cushion side shield (includes new retainers attached).
-
Attach the side air bag wire harness pin-type retainers to the cushion side shield.
20. Put the spring clip on the manual recliner handle. Align it to the recliner and push in, seating the spring clip.
21. Install the front seat. For additional information, refer to Seat - Front See: Service and Repair/Front Seat/Seat - Front.
Seat Cushion Cover - Front
Seat Cushion Cover - Front
Removal and Installation
1. Remove the front seat backrest. For additional information, refer to Seat Backrest - Front, Without Fold Flat See: Seat Back/Service and
Repair/Removal and Replacement/Front Seat/Seat Backrest - Front, Without Fold Flat or Seat Backrest - Front, With Fold Flat See: Seat
Back/Service and Repair/Removal and Replacement/Front Seat/Seat Backrest - Front, With Fold Flat.
2. NOTE: Trim cover J-clip configurations vary with seat option.
Release all the remaining J-clips attaching the trim cover to the cushion frame.
3. NOTICE: Use care when separating the seat cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn
from the cushion foam pad.
Release the hook-and-loop strips, remove the hog rings (if equipped), separate the cushion trim cover from the cushion foam pad and remove.
4. To install, reverse the removal procedure.
